Furuno FS-5070 - Manual (Page 175)

11. MAINTENANCE & TROUBLESHOOTING
11-7
MSG TYPE : TEST MESSAGE
STATION ID : 001234567
PRIORITY : SAFETY
DSC FREQ : 2187.5 kHz
GO TO VIEW
Compose msg.
9. Press the CALL key to send the test call (transmission time: about seven seconds).
10. The display shows “Test message in progress!” while the test call is being transmitted.
Test
message in progress!
DSC FREQ : 2187.5 kHz
TIME TO GO : 7S
DESTINATION ID : 001234567
PRIORITY :SAFETY
After the test call is completed, the following message appears.
Waiting for test
acknowledgement.
DSC FREQ : 2187.5 kHz
TIME TO GO : 4M12S RESENDING
DESTINATION ID : 001234567
PRIORITY : SAFETY
One of the following displays appears. (“No response! Try calling again?” appears when the
timer counts down to zero, meaning no response from station.)
No response!
Try calling again?
DSC FREQ : 2187.5 kHz
DESTINATION ID: 001234567
PRIORITY: SAFETY
Test acknowledge
message received.
RESEND
Test acknowledge received No response to test call
CANCEL: STOP ALARM
11. Do the either way depending on the message shown in step 10.
Test acknowledge message received
The audio alarm sounds; press the CANCEL key to silence the alarm. The display changes
as below.