Debug types – HP 2600 User Manual
Page 378
Troubleshooting
Using Logging To Identify Problem Sources
Debug Types.
This section describes the types of debug messages the switch
can send to configured debug destinations.
Syntax: [no] debug < debug-type >
all
Configures the switch to send all debug types to the config
ured debug destination(s). (Default: Disabled)
event
Configures the switch to send Event Log messages to the
configured debug destination(s). Note: This has no effect
on event notification messages the switch routinely sends
to the Event Log itself. Also, this debug type is automatically
enabled in these cases:
• If there is currently no Syslog server address configured
and you use
logging < ip-addr > to configure an address.
• If there is currently at least one Syslog server address
configured and the switch is rebooted or reset.
(Default: Disabled)
port-access-auth
If 802.1x authentication is configured, this option shows
the varous communication messages sent between the
switch, client, and RADIUS server.
(Default: Disabled)
C-28