Cli: modifying the interface access, Reconfigure inbound telnet access, Cli: modifying the interface access -5 – HP 2600 User Manual
Page 113

Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
show console
below
[no] telnet-server
below
[no] web-management
console
Listing the Current Console/Serial Link Configuration.
This com
mand lists the current interface access parameter settings.
Syntax:
show console
This example shows the switch’s default console/serial configuration.
Interface Access
Enable/Disable
Console Control
Options
Event Log Event
Types To List
Figure 7-2. Listing of Show Console Command
Reconfigure Inbound Telnet Access.
In the default configuration,
inbound Telnet access is enabled.
Syntax:
[no] telnet-server
To disable inbound Telnet access:
HPswitch(config)# no telnet-server
To re-enable inbound Telnet access:
HPswitch(config)# telnet-server
7-5