Configuring jumbo packet operation, Overview, Configuring jumbo packet operation -19 – HP 2600 User Manual
Page 185: Overview -19
Port Status and Basic Configuration
Jumbo Packets on the Series 2800 Switches
traffic from devices on either VLAN. For a method to allow only some
ports in a VLAN to receive jumbo traffic, refer to “Operating Notes for
Jumbo Traffic-Handling” on page 10-22.
Configuring Jumbo Packet Operation
Command
Page
show vlans
10-20
show vlans ports < port-list > 10-21
show vlans < vid >
10-22
jumbo
10-22
Overview
1. Determine the VLAN membership of the ports or trunks through which
you want the switch to accept inbound jumbo traffic. For operation with
GVRP enabled, refer to the GVRP topic under “Operating Rules”, above.
2. Ensure that the ports through which you want the switch to receive jumbo
packets are operating at least at gigabit speed. (Check the
Mode field in
the output for the
show interfaces brief < port-list > command.)
3. Use the
jumbo command to enable jumbo packets on one or more VLANs
statically configured in the switch. (All ports belonging to a jumbo-
enabled VLAN can receive jumbo packets.
4. Execute
write memory to save your configuration changes to the startup
config file.
10-19