Marantz AV8003 - Manual (Page 86)

CONNECTIONS
SETUP
BASIC
OPERA
TION
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
REMOTE
CONTROLLER
83
ENGLISH
4. This screen changes to HOME mode. Press
the button next to the displayed device name
whose commands you want to learn.
Note:
In Home mode, learning cannot be performed with the
SOFT button using the procedure shown below. Use
the Wizz.it 3 editor to make any changes.
5. After selecting the device name, press the
button whose command you want to learn.
6. This enters the learning standby mode.
Press the remote controller button that you
want to have learn the command. Hold down
the button until “LEARN OK” is displayed on the
remote controller’s LCD.
Send the remote controller code that you want
to learn.
7. The remote controller has completed learning
when “LEARN OK” is displayed on the LCD.
• Pressing the ENTER button enables you
to continue learning commands for another
button in the same device mode.
• When the learning mode is completed,
press the Home button three times to return
the LCD to the MAIN MENU.
Notes:
• If learning could not be performed, “LEARN
ERROR” is displayed on the LCD. Try performing
steps 5 to 6 again.
• When making the learning settings, the “LEARN
ERROR” message may occasionally be displayed
repeatedly on the LCD. In some cases, this can be
due to transmission of a special remote controller
signal code. Learning cannot be performed when a
special remote controller signal code is used.
• The RC2001 can learn up to a maximum of 1,000
remote controller codes. Once 1,000 codes are
programmed for learning, “LEARNFULL” is
displayed on the LCD, and learning can no longer
be performed.
To perform further learning, use the Wizz.it 3 editor
to delete any unneeded learning codes.
AV8003_U_Eng.indb 83 AV8003_U_Eng.indb 83 08.4.28 10:40:42 AM 08.4.28 10:40:42 AM