Marantz AV8003 - Manual (Page 32)

CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
OPERA
TION
REMOTE
CONTROLLER
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
SETUP
29
ENGLISH
ERROR MESSAGES
Displayed Error Cause How to Remedy
MIC SET ERROR!!
A U T O S E T U P
A U T O S E T U P : S T A R T
M A I N Z O N E
S U R R B A C K : 2 C H
M I C S E T E R R O R ! !
R E T U R N E X I T
• The microphone is not properly connected. • Connect the included microphone.
• Check the microphone connection.
NOISE ERROR!!
A U T O S E T U P
S P E A K E R S C H E C K :
N O I S E E R R O R ! !
R E T U R N E X I T
• There is too much noise in the listening room to measure properly.
• Volume from the speakers is low.
• During measurement, turn off devices that make noise such as air
conditioners.
• Measure at a time when the surrounding area is quiet.
ANALYZE ERROR!!
A U T O S E T U P
S P E A K E R S C H E C K :
A N A L Y Z E E R R O R ! !
R E T U R N N E X T E X I T
* Under ANALYZE ERROR, select “NEXT” with the 3 / 4 cursor
buttons and press the ENTER button. A detail screen like the
following appears on the display.
S P E A K E R C O N F I G
C H E C K ! ! S P E A K E R
F R O N T L : Y E S R E V
C E N T E R : N O N
F R O N T R : Y E S R E V
S U R R . R : N O N E R R
S U R R . B R : Y E S E R R
S U R R . B L : Y E S E R R
S U R R . L : N O N E R R
S U B W : Y E S
R E T U R N E X I T
• The speakers required for suitable playback were not detected.
• Speaker polarity is connected backwards.
In the examples at left, the following trouble is detected.
• The polarity of the left and right channels of the front speakers is
backwards ([REV] appears on the display.)
• The surround speaker is not connected ([NON] is displayed), but
the surround back speaker is connected
(In this kind of situation, [ERR] is displayed for all surround and
surround back speakers.)
An error is indicated in addition to the above if the speakers are
connected as follows.
• When using just one surround back speaker, but it is connected to
the surround back R-channel
(To use just one surround back speaker, connect it to the L-
channel.)
• Check the speaker that is indicated as having reversed polarity
([REV] can appear with some speakers even when properly
connected. In such case, ignore the error indication.)
• Check speaker direction and layout
AV8003_U_Eng.indb 29 AV8003_U_Eng.indb 29 08.4.28 10:40:12 AM 08.4.28 10:40:12 AM