Adept s350 Cobra - Manual (Page 52)

Chapter 5: System Operation
Figure 5-1. Brake Release Button for Third and Fourth Axes
CAUTION: When the Brake Release button is pressed,
Joint 3 may drop to the bottom of its travel. To prevent
possible damage to the equipment, make sure that Joint 3
is supported while releasing the brake and verify that the
end-effector or other installed tooling is clear of all
obstructions.
5.3 Front Panel
2
3
4
Auto
Mode
Manual
Mode
5
1
Figure 5-2. Front Panel
1. XFP connector
Connects to the XFP connector on the SmartController.
2. System 5 V Power-On LED
Indicates whether or not power is connected to the robot.
Adept Cobra s350 User's Guide, Rev. D
Page 52 of 94