Industrial Data Systems IDS DT200 - Manual (Page 36)

DT 200 Users Manual version 1.E Diagnostic Tests
32
DEFAULT PRINT FORMATS. The print formats (PAGES) are initialized to factory
settings when the Initialize System Parameters function is used. (parameter function 73).
Modify or Design a Print Format
1. Hold the CLEAR key down and press the ENTER key to enter the configure mode.
Enter CFG number 65.
2. The DT200 prompts “PAGE”. Enter the Page number that you want to modify.
3. The DT200 prompts “Px E1” where x is the page number that you entered and E1
indicates that the current entry being modified is entry 1. Press the ENTER key.
4. The DT200 prompts “L x” where x is the line number on the page that entry 1 is to
print on. Enter a new line number or press ENTER to use the displayed number.
5. The DT200 prompts “C x” where x is the column number on the page that entry 1 is
to print on. Enter a new column number or press ENTER to use the displayed
number.
6. The DT200 prompts “i x” where x is the item number that is to be printed. (See
Print Item List for a description of items that can be printed). Enter a new item
number or press the ENTER key to use the displayed number.
7. The DT200 prompts “Px E2”. Use the procedure above to modify entry 2. Use the
UNITS key ( ↓) to scroll forward in the page table, use the PRINT key (↑) to scroll
backwards.
8. Enter a zero (0) for the line number (L 0) after the last entry that is to be printed.
Press the CLEAR key to exit from the current page. NOTE: it the 16 th entry is used,
then a zero entry for the line number is not necessary.