Industrial Data Systems IDS DT200 User Manual
Page 13
DT 200 Users Manual version 1.E
Built In Application Programs
9
CLEAR TARE:
Press the numeric Zero key. Press the TARE key. The tare weight is cleared to zero
and the DT200 switches to the GROSS mode.
Gross/Net
Press the Gross/Net key to alternate between Gross and Net display modes.
Press the PRINT key to print weight data. Page format 1 is printed if the DT200 is in
Gross display mode; page format 2 is printed in the Net display mode. See section
Parameter Functions for setup of print formats.
F1 and F2
The F1and F2 keys can be configured (parameters 57 and 58) to execute any scale basic
function.
When the indicator is in data entry mode, the F1 key can be used for entering a
minus sign; the F2 key can be used to enter a decimal point.
Memory Register Entry
Use the numeric keypad to enter the memory register number (1 to 16). Press the
ENTER key. The DT200 displays "reg xx" for 1 second and then displays the current
memory register value. Press the CLEAR key if no change is to be made, or enter a new
value and then press the ENTER key. Memory registers are used by the Event Monitor
to calculate setpoint values. NOTE: memory registers are set to zero at power up unless
the battery back up is enabled (parameter 41).
Execute a Scale Basic Function
The DT200 provides up to 16 user programmable functions. User programs 1 thru 16 can
be executed by entering 21 to 36 respectively. See the "Scale Basic / Event Monitor"
manual for more information.
Display Time/Date
Enter 19 to display the time, press Enter key to display the date, press Enter again to
return to Gross/Net display.