Parameter functions – Industrial Data Systems IDS DT200 User Manual
Page 33
DT 200 Users Manual version 1.E
Diagnostic Tests
29
Parameter Functions
The parameter functions are used to set parameters that are too complex for a single
numeric entry. The following table lists the parameter functions:
Parameter Functions
Fn. No Function Name
Password Level
59
Display Calibration Audit Number
0
60
3
61
3
62
3
63
3
64
Configure Passwords
2
65
Configure Print Formats
2
66
Set Time and Date
2
67
Display Operation Parameters
0
68
Print Operation Parameters
0
69
Diagnostic Tests
0
70
Initialize Operation Parameters to factory defaults.
3
71
Configure Event Monitor
2
72
Function Editor
2&3
73
Initialize Function Memory
2
74
Set Debug mode for Event monitors and Scale basic fns.
2
75
Enable Peak Detect (optional)
2
76
Set debug mode for event monitors and scale basic fns.
2
78
Erase Id Memory
1
79
3
80
3
81
Analog output offset (default = 0)
1
82
Analog output span (default = 10,000)
1
83
Analog output register (default = 0 [disabled])
1
84-90
Print labels 4 to 10
91
Serial Port 3 mode
4
92
Serial Port 3 baud rate
1
93
Serial Port 3 input format (default = 1 [Condec])
1
The Password Level is used to prevent unauthorized access to parameter functions. See
Parameter Function 64, “Configure Passwords”, for more information on passwords.