Lantronix XPORT PROTM 900-560 - Manual (Page 129)

13: Advanced Settings
XPort Pro User Guide 129
Figure 13-5 CLI Configuration
2. Enter or modify the following settings:
Table 13-6 CLI Configuration
3. Click Submit .
Command Line Interface
Configuration Settings Description
Login Password Enter the password for Telnet access.
Enable Level Password Enter the password for access to the Command Mode Enable level. There is
no password by default.
Quit Connect Line Enter a string to terminate a connect line session and resume the CLI. Type
before any key the user must press when holding down the Ctrl
key. An example of such a string is L.
Inactivity Timeout Set an Inactivity Timeout value so the CLI session will disconnect if no data is
received after the designated time period. Default is 15 minutes. Enter a
value of 0 to disable.
Telnet State Select Disabled to disable Telnet access. Telnet is enabled by default.
Telnet Port Enter the Telnet port to use for Telnet access. The default is 23.
Telnet Max Sessions Maximum number of simultaneous Telnet sessions. The default is 3 and the
maximum is 10.
SSH State Select Disabled to disable SSH access. SSH is enabled by default.
SSH Port Enter the SSH port to use for SSH access. The default is 22.
SSH Max Sessions Maximum number of simultaneous SSH sessions. The default is 3 and the
maximum is 10.