Lantronix XPORT PROTM 900-560 - Manual (Page 112)

12: Maintenance and Diagnostics Settings
XPort Pro User Guide 112
4. Click Submit.
IP Address Filter
The IP address filter specifies the hosts and subnets permitted to communicate with the XPort Pro
device. When the filter list is empty, then all IP addresses are allowed.
Note: If using DHCP/BOOTP, ensure the DHCP/BOOTP server is in this list.
To configure the IP address filter:
1. Select IP Address Filter on the menu bar. The IP Address Filter page opens to display the
current configuration.
Figure 12-14 IP Address Filter Configuration
Note: If you enter any filter, be careful to make sure that your network IP address is
covered. Otherwise you will loose access to the XPort Pro. You will have to then access
the XPort Pro from a different computer to reset the configuration.
2. Enter or modify the following settings:
Table 12-15 IP Address Filter Settings
3. Click Add.
Note: In the Current State table, click Remove to delete any existing settings, as
necessary.
IP Address Filter
Settings Description
IP Address Enter the IP address to add to the IP filter table.
Network Mask Enter the IP address’ network mask in dotted notation.