FUJITSU C-4120 - Manual (Page 79)

T r o u b l e s h o o t i n g
L i f e B o o k C S e r i e s f r o m F u j i t s u
65
Problem Possible Cause Possible Solution
Five
You can not access your hard drive (continued). 2. The wrong drive designator was used by an 2. Verify drive designator used by application
application when a bootable CD-ROM was is in use by the operating system. When the
used to start the notebook. operating system is booted from a CD-ROM,
drive designations are automatically adjusted.
(See Primary Master Submenu in the BIOS
guide. See page 44 for more information.)
3. Security is set so operating system can not 3. Verify your password and security settings.
be started without a password. (See Security menu in the BIOS guide. See
page 44 for more information.)
Keyboard or Mouse Problems
The built-in keyboard does not seem to work. 1. The notebook has gone into Suspend mode. 1. Push the Suspend/Resume button.
2. Your application has locked out 2. Try to use the ErgoTrac pointing device
your keyboard. to access the Start menu and then the
ShutDown menu and restart the System.
If this fails, then reset your notebook
using the reset button located on the
rear panel.
You have installed an external keyboard. 1. Your external device is not properly installed. 1. Re-install your device.
External keyboard is not functioning.
2. Your operating system software is not setup 2. Check your device and operating system
with the correct software driver for that device. documentation and activate the proper driver.