FUJITSU C-4120 User Manual

Page 63

Four

U s e r I n s t a l l a b l e F e a t u r e s

L i f e B o o k C S e r i e s f r o m F u j i t s u

Replacing the Battery
The battery is installed in the battery bay on the
underside of your notebook. (See Figure 4-1.)
With the purchase of an additional battery, you
can have a fully charged spare to swap with one
that is not charged. To swap batteries, have a
charged battery ready to install and follow the
steps below:

1. Press the Power button to put the notebook

into suspend mode. (Or shut down your
notebook and disconnect the AC adapter if
you wish to cold-swap.)

2. Close your display and stand your notebook

on it's right panel with the top facing you.

3. Press down on the battery release panel and

slide it way from you.

4. Set your notebook down gently on it's top, with

the left panel facing you.

5. Slide the battery pack away from the connector

until it stops.

6. Lift the battery out of the bay.

Figure 4-1 Replacing the Battery

7. Place the charged battery flat into the bay

with the bottom up and the release panel
away from you, approximately one quarter
inch away from the connector in
the notebook.

8. Slide the new battery onto the connector.

9. Slide the battery release panel down until it

clicks into place.

10. Press the Power button to resume from

suspend mode if you are warm-swapping, or
to power on your notebook if cold-swapping.

Batteries should be removed and stored sepa-
rately in a cool dry place if your notebook is not
going to be used for an extended period of time.

C A U T I O N

If the Lithium ion battery connector is not
fully seated, you may not be able to use
your notebook or charge your battery.