Hitachi HCX5000I - Manual (Page 60)

C HAPTER 1: A BOUT Y OUR S ELEC S ET 500A B RIDGED CAP S TO C REATE A
HCXTD840, Issue 1, July 2001 1-49
5 Press the key again to join the two CAPs or:
To transfer the call to the caller on CAP1 press
. You are out of the conference once you press
the key.
If your system administrator has set up your phone
system with the multiparty conference capability, you
can place a conference on hold after connecting the
two parties on CAP 1 and CAP 2. You can then take
another call by pressing the key.
Both the CAP key with the conference and the
key flash slowly. At least one of these
conferenced members should be an internal party to
prevent trunk-to-trunk lockup.
Otherwise, remove yourself from the conference if an
incoming internal caller is connected with an outside
caller.
Note: If three CAPs are busy, you cannot use CAP 4
to initiate a conference or to join or bridge two parties.
6 To disconnect the last party from the conference (the
caller on CAP1), press the key.