HP E1368A - Manual (Page 72)

Command Quick Reference
The following tables summarize SCPI and IEEE 488.2 Common (*)
Commands for the Microwave Switch modules.
SCPI Commands for Quick Reference
Command Description
ABORt Abort a scan in progress.
ARM :COUNt < number > MIN | MAX
:COUNt? [MIN | MAX]
Multiple scans per INIT command.
Query number of scans.
DISPlay:MONitor:CARD < number > | AUTO
:MONitor[:STATe] < mode >
:MONitor[:STATe]?
Selects module to be monitored.
Selects monitor mode.
Query the monitor mode state.
INITiate :CONTinuous < mode >
:CONTinuous?
[:IMMediate]
Enables/disables continuous scanning.
Query continuous scan state.
Starts a scanning cycle.
OUTPut [:STATe] < mode >
[:STATe]?
Enables/disables "Trig Out" pulse.
Query port enable state.
[ROUTe:] CLOSe < channel _list >
CLOSe? < channel _list >
OPEN < channel _list >
OPEN? < channel _list >
SCAN < channel _list >
SCAN:MODE NONE | VOLT | RES
SCAN:MODE?
Close channel(s).
Query channel(s) closed.
Open channel(s).
Query channel(s) opened.
Define channels for scanning.
Selects scan mode.
Query state of scan mode.
STATus:OPERation:ENABle
:OPERation:ENABle
:OPERation[:EVENt]?
Enables the Operation Status Register to set a bit in the
Status Register.
Query the contents in the Operation Status Register.
Returns status of the Operation Status Register.
SYSTem :CDEScription? < number >
:CPON < number > | ALL
:CTYPe? < number >
:ERRor?
Returns description of module in a switchbox.
Sets specified module to its power-on state.
Returns the module type.
Returns error number/message in a switchbox Error Queue.
TRIGger [:IMMediate]
:SOURce BUS
:SOURce EXTernal
:SOURce HOLD
:SOURce IMMediate
:SOURce? Causes a trigger to occur.
Trigger source is *TRG.
Trigger source is "Event In" BNC.
Hold off triggering.
Continuous (internal) triggers.
Query scan trigger source.
IEEE 488.2 Common Commands Quick Reference
Command Title Description
*RST Reset Opens all channels, and invalidates current channel list for scanning.
Sets ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
*TRG Bus Trigger When scan is enabled and trigger source is TRIG:SOUR BUS, use the *TRG
command to trigger the switchbox to advance the scan.
*TST? Self Test query Always returns 0.
Chapter 4 HP E1368A/69A/70A Command Reference 71
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com