HP E1368A - Manual (Page 32)

Switching Channels
For general purpose switch operation, you can connect or disconnect a
signal by opening or closing a specific channel.
•
Use CLOS < channel_list > to close coaxial switch channel(s), and
OPEN < channel_list > to open coaxial switch channel(s). Refer to
Figure 2-6 for the various HP coaxial switch configurations.
< channel_list > has the form (@ccnn) where cc = card number
(01-99) and nn = channel number (00-04).
Example: Single
Channel Switching
This example illustrates closing and opening channel 00 in a HP E1368A
Microwave Switch module. Figure 3-1 shows how the channel is
configured.
To close channel 00, execute:
CLOS (@100) Connect channel 00 switch port 2
to port C, and terminate port 1 into
50; 1 is the card number and 00 is
the channel number.
To open channel 00, execute:
OPEN (@100) Connect channel 00 switch port 1
to port C, and terminate port 2 into
50; 1 is the card number and 00 is
the channel number.
Figure 3-1. Example: HP E1368A Single Channel Switching
Chapter 3 Using the HP E1368A/69A/70A Modules 31
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com