Setting the address switch – HP E1368A User Manual
Page 19
Setting the Address Switch
The logical address switch (LADDR) factory setting is 120. You may have
changed the setting during module installation. Valid address values are
from 0 to 255. If the Microwave Switch modules are used in a HP
E1300/E1301 Mainframe, refer to the HP 75000 Series B System
Installation and Getting Started Guide for addressing information.
Otherwise, use Figure 2-1 to change the setting.
Note
The address switch selected value must be a multiple of 8 if the module is
the first module in a "switchbox" used in a VXIbus mainframe, and being
instructed by SCPI commands.
Figure 2-1. Logical Address Selection
18 Configuring the HP E1368A/69A/70A Modules
Chapter 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com