HP E1368A - Manual (Page 30)

Chapter 3
Using the HP E1368A/69A/70A Modules
Using This Chapter
This chapter uses typical examples to show how to use the Microwave
Switch modules. This chapter contains the following sections:
•
Microwave Switch Commands . . . . . . . . . . . . . . . . . . . . . . . Page 29
•
Reset Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 30
•
Switching Channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 31
•
Scanning Channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 39
•
Recalling and Saving States. . . . . . . . . . . . . . . . . . . . . . . . . . Page 43
•
Detecting Error Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . Page 43
•
Synchronizing the Microwave Switch. . . . . . . . . . . . . . . . . . Page 45
•
Querying the Microwave Switch . . . . . . . . . . . . . . . . . . . . . . Page 46
Microwave Switch Commands
Table 3-1. Microwave Switch Commands in Chapter 3
Command Command Description
INIT[:IMM] Starts the scan sequence and closes the first channel in
the
channel list .
OUTP[:STAT] ON Enables the HP E1300A/E1301A "Trig Out" port to
output pulses.
[ROUT:]CLOS < channel_list > Close the channels in the channel list .
[ROUT:]CLOS? < channel_list > Query the state of the channels in the channel list .
[ROUT:]OPEN < channel_list > Open the channels in the channel list .
[ROUT:]SCAN < channel_list > Closes the channels in the channel list one at a time.
TRIG:SOUR BUS|EXT|HOLD|IMM Select the trigger source to advance the scan.
*CLS Clears all switchbox Status Registers.
*ESE Enables the Event Status Register.
*RST Sets the hardware and software to a known state.
*SRE Enables the Status Register.
Chapter 3 Using the HP E1368A/69A/70A Modules 29
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com