HP E1368A - Manual (Page 59)

[ROUTe:]
The ROUTe subsystem controls switching and scanning operations for the
Microwave Switch modules in a switchbox.
Subsystem Syntax [ROUTe:]
CLOSe < channel_list >
CLOSe? < channel_list >
OPEN < channel_list >
OPEN? < channel_list >
SCAN < channel_list >
:MODE NONE | VOLT
:MODE?
CLOSe
[ROUTe:]CLOSe < channel_list > closes the Microwave Switch channels
specified in the channel_list. The channel_list is in the form (@ccnn)
where cc = card number (00-99) and nn = channel number (00-04).
Parameters
Parameter Name Parameter Type Range of Values Default Value
channel_list numeric cc00 - cc04 N/A
Comments
•
Closing Channels: To close:
– a single channel, use [ROUTe:]CLOSe (@ccnn) ;
– multiple channels, use [ROUTe:]CLOSe (@ccnn,ccnn) ;
– sequential channels, use [ROUTe:]CLOSe (@ccnn:ccnn) ;
– a group of sequential channels, use
[ROUTe:]CLOSe (@ccnn:ccnn,ccnn:ccnn) ;
– or any combination.
Closure order for multiple channels with a single command is not
guaranteed.
•
Related Commands: [ROUTe:]OPEN , [ROUTe:]CLOSe?
•
*RST Condition: All channels are open.
Example Closing Microwave Switch Channels
This example closes channels 100 and 202 of a two-module switchbox (card
numbers 01-02).
CLOS (@100,202) 100 closes channel 00 of card #1;
202 closes channel 02 of card #2.
58 HP E1368A/69A/70A Command Reference Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com