HP E1368A User Manual
Page 28
After selecting the coaxial switch or attenuator, install as follows:
1. Position the coaxial switch or attenuator behind the panel cut-out.
Use two M3.0 x 8mm (P/N 0515-0372) metric screws to secure the
rear panel. Use two 4-40 x .25 inch screws (P/N 2200-0521) to
secure the attenuator to the rear panel.
2. Route the ribbon cable from the Microwave Switch or Attenuator to
the 14-pin connector on the PC board.
3. Install the correct filler panel on the switch so that minimal air can
flow through the slot.
Figure 2-7. Microwave Switch/Attenuator Installation
Chapter 2
Configuring the HP E1368A/69A/70A Modules 27
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com