HP Photosmart 7200 Series User Manual
Page 18
hp photosmart 7200 series
chapter 1
14
5
Grasp the pink tab and gently peel off the clear plastic tape. Make sure
you remove only the clear tape. Be sure to install the print cartridge
immediately after removing the tape; ink nozzles exposed longer than one
minute may dry out and cause printing problems later. Once the tape is
removed, do not attempt to replace it.
Caution! Do not touch the ink nozzles or the copper contacts on the print
cartridge. Touching these parts may cause the print cartridge to fail.
6
Insert the print cartridge:
Note: The tri-color print cartridge must be installed in the left stall of the print
cartridge cradle. The black or the photo print cartridge must be installed in
the right stall of the print cartridge cradle.
a. Hold the print cartridge so the copper contacts go into the print
cartridge cradle first. Line up the ridges on the left and right sides of the
top of the print cartridge with the grooves on the inside of the print
cartridge cradle. The label on the print cartridge should face upwards.
a. Carefully slide the print cartridge into the print cartridge cradle at a
slight angle, then firmly push the print cartridge in until it snaps into
place.
7
Repeat steps 3–6 to install the second print cartridge.
8
Close the main cover.
Ink nozzles
Copper contacts