HP ML100 - Manual (Page 73)

6.
a. rocessor terminator board
b.
c.
with one or more of the original processors. Install each
e by one, restarting each time, to find the
r configurations at each step are compatible
with the server requirements.
System e
Action:
If the server has multiple processors installed, test each processor:
Remove all but one processor from the server. Replace each with a p
or blank, if applicable to the server.
If the server includes PPMs that are not integrated on the system board, remove all PPMs from the
server except for the PPM associated with the remaining processor.
Replace the remaining processor with a known functional processor. If the problem is resolved
after you restart the server, a fault exists
processor and its associated PPM (if applicable) on
faulty processor or processors. Be sure the processo
op n circuits and short circuits
CAUTION: Do not operate the server for long periods with the access panel open or
removed. Operating the server in this manner results in improper airflow and improper
age. cooling that can lead to thermal dam
1. Check the server LEDs to see if any statuses indicate the source of the problem. For LED information,
2. all power sources to the server.
ach component in this
Resta e if the problem has been corrected.
• tions (on page 50) exist in the rest of the server, particularly with the cables
.
ts, such as screws, bits, or slot bracket blanks, that may be short
circuiting components.
External device problems
Video problems
Screen is blank for more than 60 seconds after you power up the server
he monitor is receiving
2.
3.
Be
4. Be sure no ons (on page 50) exist.
refer to the server documentation.
Remove
3. Be sure no loose connections (on page 50) exist in the area.
4. Be sure each component in the area is working. Refer to the section for e
guide.
If you cannot determine the problem by checking the specific area, perform each of the following actions.
rt the server after each action to se
• Reseat all I/O expansion boards.
Be sure no loose connec
that connect to the system board
• Be sure no foreign material exis
Action:
1. Power up the monitor and be sure the monitor light is on, indicating that t
power.
Be sure the monitor power cord is plugged into a working grounded (earthed) AC outlet.
sure the monitor is cabled to the intended server or KVM connection.
loose connecti
Troubleshooting 73