Henny Penny PFE-592 User Manual
Page 37
Model 590/592
10. Replace the brass nuts and washers on the heating element
terminals. Tighten the brass nuts to 30 foot lbs of torque.
11. Replace heat contactor.
12. Move the element spreaders from the center of the ele
ment, into a position which will spread each element apart
evenly on all four sides, and tighten.
13. Replace the high limit bulb holder on the top element, and
position the bulb between the top and second element mid-
way from side to side, and tighten screw which holds the
bulb in place.
14. Reconnect the wires to the appropriate terminal as labeled
when they were removed.
15. Replace the front control shroud and control panel.
16. Replace side panels.
17. Connect the power cord to the wall receptacle or close
wall circuit breaker.
Heating elements should never be energized without
shortening in the frypot, or damage to elements could
result.
1103
2-21
2-20. HEATING ELEMENTS
(Continued)