Heat & Glo Fireplace 6000TRS-CE - Manual (Page 36)

Heat & Glo • 6000TRS-CE • 2049-900 Rev. R • 3/13 36
Placing the Ember Material
Two bags of ember material are shipped with this gas fireplace.
Use only a portion of each bag for the best appearance and
operation.
To place the ember material:
• Remove latches and tension springs around the glass door.
• Remove the glass door from the unit (Figure 33).
Figure 34. Placement of the Ember Material
Figure 33. Glass Assembly
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
• Place small pieces of ember material on burner top (Figure
34). Do NOT press embers into burner ports. Cover the top
of the burner with a single layer of ember material. Do NOT
place embers on the ports as noted in Figure 34.
• Save the remaining ember materials for use during fireplace
servicing.
• Replace the glass door and a front trim door on the unit
(see Replacement Parts Section of the manual.)
• Replace the latches and tension springs.