Heat & Glo Fireplace 6000TRS-CE - Manual (Page 29)

Heat & Glo • 6000TRS-CE • 2049-900 Rev. R • 3/13 29
The diagram below shows how to properly position,
level, and secure the fireplace.
Step 4
Positioning,
Leveling, and
Securing the
Fireplace
Figure 27. Gas Control System
!
!
STANDING PILOT
NAILING TABS
(BOTH SIDES)
wARNING: 230 vAC MUST NEvER BE
CONNECTED TO A CONTROL vALvE IN
A MILLIvOLT SYSTEM.
Figure 26. Proper Positioning, Leveling, and Securing of a
Fireplace
1. Place the fireplace into
position.
2. Level the fireplace
from side to side and
from front to back.
3. Shim the fireplace with
non-combustible ma-
terial, such as sheet
metal, as necessary.
4. Secure the fireplace to
the framing by nailing
or screwing.
Step 5
The Gas Control
System
wARNING: THIS UNIT IS NOT FOR USE
wITH SOLID FUEL.
Standing Pilot Ignition System
This system includes millivolt control valve, standing
pilot, thermopile/thermocouple flame sensor, and
piezo ignitor.