Home Dynamix DW 3512 - Manual (Page 42)

Dynamix DW 3512 Technical Manual V1.00
Copyright © 2007 Dynamix Pro., Ltd. All right reserved. 42
2) T.38 Port: Set T.38 port for FAX.
¾ Hot Line
1) Use Hot Line: Check to enable Hot Line function.
2) Hot Line Number: Set the destination number for Hot Line function..
¾ DND (Don’t Disturb)
1) DND Mode: You can select 3 mode of DND. The call will be always rejected if Always is
selected. The call will be rejected by below Time setting (From and To) if Enable is
selected. The call will be accepted if Disable is selected.
2) From: Set the start time for DND with Enable mode.
3) To: Set the end time for DND with Enable mode.
You can check the current time by the page of Time Zone Setting.
¾ DSP
1) FXS Volume
i. Handset Gain: Set Handset receiver volume from 1 to 10.
ii. Handset Volume: Set Handset transmit volume from 1 to 10.
2) VAD: Check to enable VAD (Voice Activity Function) function.
3) Caller ID Mode: Select caller ID mode as FSK(Bellcore), FSK(ETSI), FSK(BT), FSK(NTT),
or DTMF from FXS to send out.
4) FSK Date & Time Sync: Check to send FSK Date and Time to caller ID display device.
5) Reverse Polarity before Caller ID: Check to send reverse polarity before caller ID.
6) Short Ring before Caller ID: Check to send short ring before caller ID.
7) Dual Tone before Caller ID: Check to send dual tone before caller ID.
8) Caller ID Prior First Ring: Check to send caller ID before first ring.
9) Caller ID DTMF Start Digit: Set caller ID DTMF start digit.
10) Caller ID DTMF End Digit: Set caller ID DTMF end digit.
11) Flash Time Setting (ms) [ Space:10 , Max:2000 ]: Set Minimum and Maximum Flash time.
12) Speaker Voice Gain (dB) [ -32~31 ],Mute:-32: Set Speaker voice volume.
13) Mic Voice Gain (dB) [ -32~31 ],Mute:-32: Set microphone voice gain volume.