Setup wizard, Operation mode – Home Dynamix DW 3512 User Manual

Page 16

Dynamix DW 3512 Technical Manual V1.00

Setup Wizard

The setup wizard will guide you to configure access point for first time. Please follow the setup

wizard step by step.

Press Cancel will return to the first page of Setup Wizard.

Press Next>> to next step.

Press <

Press Finished will save all configurations and DW3512 will reboot.

Operation Mode:

You can setup different modes to LAN and WLAN interface for NAT and bridging function. DW3512

provide all 3 primary modes and 4 extended modes. Here you can find 3 primary modes, including:

1) Gateway mode, 2) Bridge mode, 3) Wireless ISP. Another 4 extended modes are changes from

these 3 mainly modes and plus some application, including: 1) Client mode, 2) WDS Repeater

Mode, 3) Universal Repeater mode, 4) WISP + Universal Repeater mode.

Gateway: In this mode, the device is supposed to connect to internet via ADSL/Cable Modem.

The NAT is enabled and PCs in four LAN ports share the same IP to ISP through WAN port.

The connection type can be setup in WAN page by using PPPOE, DHCP client or static IP.

Bridge: In this mode, all ethernet ports and wireless interface are bridged together and NAT

function is disabled. All the WAN related function and firewall are not supported

Wireless ISP: In this mode, all ethernet ports are bridged together and the wireless client will

connect to ISP access point. The NAT is enabled and PCs in ethernet ports share the same IP

to ISP through wireless LAN. You must set the wireless to client mode first and connect to the

ISP AP in Site-Survey page. The connection type can be setup in WAN page by using PPPOE,