Home Dynamix DW 3512 - Manual (Page 30)

Dynamix DW 3512 Technical Manual V1.00
Copyright © 2007 Dynamix Pro., Ltd. All right reserved. 30
„ Access Control
If you choose Allowed Listed, only those clients whose wireless MAC addresses are in the access
control list will be able to connect to your Access Point. When Deny Listed is selected, these
wireless clients on the list will not be able to connect the Access Point.
¾ Wireless Access Control Mode: Set disable control, allow list or deny list.
If user set control mode as Allow Listed, please add MAC address below to increase Allow
List. If user set control mode as Deny Listed, please add MAC address below to increase
Deny List.
¾ MAC Address: Input MAC address for allow or deny list.
¾ Comment: Give description for each data.
¾ Current Access Control List: Show current control list.
¾ User can press Delete Selected to delete specified data or press Delete All to delete all lists.
„ WDS Settings
Wireless Distribution System uses wireless media to communicate with other APs, like the Ethernet
does. To do this, you must set these APs in the same channel and set MAC address of other APs
which you want to communicate with in the table and then enable the WDS.
¾ Enable WDS: Enable WDS to start transmitting and receiving WDS packets. You can only use
this feature when wireless mode set to WDS or AP+WDS.
¾ MAC address: Enter 12 digits in hex numbers in this field and press Apply Changes to
associate with other’s Wireless access point. Before you want to use WDS Repeater mode,
you have to enter the other’s AP/Router MAC address that the device want to connect.
¾ Reset: Reset the settings of WDS.