HP ProLiant DL145 - Manual (Page 95)

HP ProLiant DL145 Server User Guide F-1
F
Troubleshooting
This appendix provides specific troubleshooting information for the server. Use it to diagnose
server startup and installation problems.
For information on LEDs, switch settings, and jumpers, refer to Chapter 1, “Server
Component Identification.”
If the Server Does Not Start
This section provides step-by-step instructions when encountering the most common
problems during the initial Power-On Self-Test (POST). Every time the server boots, it must
complete POST before it can load the operating system and start running software
applications.
If the server completes POST and attempts to load the operating system, go to “Problems
After Initial Startup” in this appendix.
WARNING: There is a risk of personal injury from hazardous energy levels. The
installation of options and the routine maintenance and service of this product must be
performed by individuals who are knowledgeable about the procedures, precautions,
and hazards associated with equipment containing hazardous energy circuits.
If the server does not start:
1. Be sure that the server and monitor are plugged into a working outlet.
2. Be sure that the power source is working properly:
— Confirm status using the power LED. Refer to Chapter 1, “Server Component
Identification” for the location and status of the power LED.
— Confirm that the power button was pressed firmly.