HP ProLiant DL145 - Manual (Page 36)

Hardware Options Installation
4-6 HP ProLiant DL145 Server User Guide
4. Install the DIMMs.
Figure 4-7: Installing a DIMM
5. Reinstall the access panel.
6. Restore the server to its operating position in the rack.
7. Power up the server.
Removing a Media Bay Blank or a DVD Drive
To remove a media bay blank or a DVD drive:
1. Power down the server. Refer to “Powering Down the Server” in Chapter 2, “Server
Operations.”
2. Extend the server from the rack. Refer to “Extending the Server from the Rack” in
Chapter 2, “Server Operations.”
3. Remove the access panel. Refer to “Removing the Access Panel and the Chassis
Stiffener” in Chapter 2, “Server Operations.”
4. Remove the chassis stiffener. Refer to “Removing the Access Panel and the Chassis
Stiffener” in Chapter 2, “Server Operations.”
NOTE: If only one IDE drive is being removed and only one SCSI drive is being installed, proceed to
step 9.