HP ProLiant DL145 - Manual (Page 72)

Operating System Installation and Software
HP ProLiant DL145 Server User Guide 5-17
Configuring Access Through the Network
The server is connected to the network using a standard Ethernet cable. Through this
connection, you can access the Management Processor CLI, verify POST remotely, and
access the BIOS Setup Utility remotely.
To set up a Telnet session:
1. Connect a standard Ethernet cable between the dedicated Management NIC on the server
rear panel and a network jack. The Management Processor automatically negotiates an IP
address.
2. Verify the IP address:
a. Establish serial communication to the server. Refer to “Configuring Access Through
the Serial Port” in this chapter.
b. Log in to the Management Processor CLI. The ProLiant> prompt appears. Refer to
“Logging Into the Management Processor Command Line Interface” in this chapter.
IMPORTANT: You must log in as an OEM or Administrator level user. For information on user
accounts, refer to “User Accounts” in this chapter.
c. Enter the network setup command. The INET> prompt appears.
d. Enter the state command. The Management Processor IP address appears.
e. Exit network setup by entering the quit command. The ProLiant> prompt appears.
f. Exit the Management Processor CLI. Refer to “Logging Out of the Management
Processor CLI” in this chapter.
3. Launch Telnet by entering the following command at a DOS prompt or the command
line:
Telnet xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the Management Processor IP address.
User Accounts
The Management Processor supports four user accounts. Use third-party IPMI software to
configure usernames and privileges. Usernames and passwords are case-sensitive and can
contain up to 16 characters each. The default accounts include:
• OEM—OEM privileges allow the user to execute the full set of CLI commands
described in Table 5-8. The default username/password is OEM / OEM .
NOTE: The default maximum privilege level for the serial channel is OEM. This default is allowed
since physical security occurs with the RS-232 interface. If a serial terminal is connected to the
RS-232 interface, the serial terminal can provide additional security measures.
• Administrator—Administrator privileges allow the user to execute the full set of CLI
commands described in Table 5-8. The default username/password is admin / admin .