HP ProLiant DL145 - Manual (Page 43)

Hardware Options Installation
HP ProLiant DL145 Server User Guide 4-13
9. Secure the drive cage.
Figure 4-19: Securing the drive cage
10. Install the DVD drive or media bay blank.
11. Reinstall the chassis stiffener.
12. Reinstall the access panel.
13. Restore the server to its operating position in the rack.
14. Power up the server.
Removing the EIDE Hard Drives
All references to left and right drives are from the front of the server.
NOTE: If two SCSI drives are to be installed, only remove the right drive.
To remove the EIDE hard drives:
1. Power down the server. Refer to “Powering Down the Server” in Chapter 2, “Server
Operations.”
2. Extend the server from the rack. Refer to “Extending the Server from the Rack” in
Chapter 2, “Server Operations.”
3. Remove the access panel. Refer to “Removing the Access Panel and the Chassis
Stiffener” in Chapter 2, “Server Operations.”
4. Remove the chassis stiffener. Refer to “Removing the Access Panel and the Chassis
Stiffener” in Chapter 2, “Server Operations.”