HP ProLiant DL145 - Manual (Page 73)

Operating System Installation and Software
5-18 HP ProLiant DL145 Server User Guide
• Operator—Operator privileges allow the user to:
— Run IPMI commands from the CLI.
— Read the Sensor Data Records Log.
— Read the System Event Log.
The default username/password is Operator / Operator .
• User—User privileges allow the user to run IPMI commands. The default username and
password are blank.
NOTE: The default maximum privilege level for the LAN channel is User level. Use third-party IPMI
software to set the access and the user privilege for the channel if more privileges are needed.
Accessing the Management Processor CLI
Through either serial or Telnet access, the ProLiant 100-series Management Processor
provides system administrators with the capability to:
• Freely switch between remote console (Console Mode) and the Management Processor
CLI (Terminal Mode).
• Remotely power on and off the server.
• Perform warm or cold server reboots.
• Configure TCP/IP settings for the dedicated Management NIC.
• Change user passwords.
• Issue raw IPMI v1.5 commands.
• Access command line help.