HP ProLiant DL145 - Manual (Page 15)

Server Component Identification
HP ProLiant DL145 Server User Guide 1-5
J9 CMOS Jumper
Figure 1-5: J9 CMOS Jumper
Table 1-5: J9 CMOS Jumper Settings
Item Setting
1 Set
2 Clear
To clear CMOS:
1. Back up the server data.
2. Shut down the operating system as directed by the operating system documentation.
3. Press the Power button to power down the server. When the server powers down, the
system power LED turns off.
4. Disconnect the power cord.
5. Set the J9 CMOS jumper to Clear and hold in position for 3 seconds.
6. Reset the J9 CMOS jumper to Set.
7. Connect the power cord.
8. Power up the system.
9. Reconfigure the server using the BIOS Setup Utility. Refer to Chapter 5, “Operating
System Installation and Software” for more information on the BIOS Setup Utility.