HP ProLiant DL145 - Manual (Page 75)

Operating System Installation and Software
5-20 HP ProLiant DL145 Server User Guide
Using CLI Commands
CLI commands are entered at the ProLiant> prompt that appears after a successful login to
the Management Processor. For more information on logging in to the Management
Processor, refer to “Logging In to the Management Processor CLI” in this chapter.
Table 5-8 lists and describes the CLI commands. The commands are described in further
detail in the sections that follow.
IMPORTANT: CLI commands are case-sensitive.
Table 5-8: Basic CLI Commands
Command Description
changepassword
Change the password.
power on
Power on the server remotely.
power off
Power off the server remotely.
ipmicommand command , where
command is a supported IPMI
command
Execute an IPMI command.
sdrread
Display the sensor data records.
selread
Display the System Event Log.
network setup* Set up the network.
reset warm
Reset the server.
reset cold
Power off the server and reset the
server after a short time has passed.
help
Display a list of commands.
quit
Log out of the Management
Processor .
* Entering network setup to configure the network results in the prompt
changing from ProLiant> to INET>. For information on additional
commands that can be entered at the INET> prompt, refer to “Setting Up
the Network” in this chapter.