HP RM500SL - Manual (Page 24)

0611 RM500SL User’s Guide Version 2.8 Page 24
5.4 Single computer connection
FastFacts 5.4: Single computer connection
The computer must be running Windows 95 or higher, with a functioning network
card connected to one port on a Ethernet network hub or switch. Connect a Cat
5, RJ-45 cable from a hub port to the RM500SL connector. To set up the PC:
1) Right click Network Neighborhood (or My Network Places) & select Properties.
2) Right click Local Area Network Connection & select Properties.
3) If Internet protocol TCP/IP is not installed, install it from your Windows disk.
4) Highlight Internet Protocol (TCP/IP) & select the Properties button.
5) Check “Use the following IP address” and enter the following in the IP address
box: 172. 30. 1. 1. Enter 255. 255. 255. 0 in the Subnet mask box.
On the RM500SL, see
5.3 Networking setup
and manually configure
as shown: