Hand Held Products 7200/UG - Manual (Page 46)

C H A P T E R 3 D O L P H I N 7 2 0 0 R F H A N D H E L D C O M P U T E R
46 46 46 46
Running the WEP.BAT Utility
This section describes usage and command line options for the WEP.BAT utility.
Note: The WEP.BAT file must be run with the radio driver NOT loaded. Reboot the
Dolphin 7200 RF terminal with the ON/SCAN key depressed so that the driver will
not load.
WEP [BATCH] [HEX] [ASCII] [STATUS] [SELECTKEY#] [CLEARKEY#]
[OPEN] [WEPSHARED] [WEPOPEN]
WEP OPTIONS
BATCH Sets radio WEP keys using the file keys.txt .
HEX Sets radio WEP keys using a hex string
entered via the keyboard.
ASCII Sets radio WEP keys using ASCII characters
entered via the keyboard.
STATUS Displays encryption level and key lengths.
SELECTKEY # Selects operating key used during operation
with access point.
CLEARKEY # Clears operating key.
OPEN Disables WEP operation even if keys have
been set (no encryption) .
WEPSHARED Sets WEP mode to WEPSHARED. In this
mode, the Access Point sends a plain-text,
shared-key query to any device attempting
to communicate with the Access Point.
WEPOPEN (default) Sets WEP mode to WEPOPEN which
allows any device, regardless of its WEP
settings, to authenticate and then attempt to
communicate with the Access Point.
N O T E
Reset the Dolphin terminal
by pressing and releasing the
<SHIFT>, <ON/SCAN>
and <BKSP> keys.
All three keys must be held
down and released
at the same time.