Hand Held Products 7200/UG - Manual (Page 128)

C H A P T E R 9 D O L P H I N O S A N D D E V E L O P M E N T S Y S T E M
128 128 128 128
Scanning A Barcode
The Dolphin Terminal comes with demonstration software that allows you to scan
barcodes immediately. A sample barcode is illustrated below for you to use for
practice.
Hold the Dolphin terminal approximately 2 inches away from the sample barcode.
Press the ON/SCAN key to begin scanning. Move the Dolphin terminal back and
forward until the unit gets a good read. The Dolphin terminal will “beep,” and the
laser will turn off when a good read is obtained. The decode LED will turn green
The Dolphin terminal will show a translation of the sample barcode on the LCD
window, which should appear similar to the following illustration.
HHP SCAN TEST
Press F1 for setup
ESC to quit
Label:
DOLPHIN
Type: