Hand Held Products 7200/UG - Manual (Page 112)

C H A P T E R 8 U S I N G T H E D O L P H I N 7 2 0 0 C O M P A C T H O M E B A S E
112 112 112 112
Back Panel
There is a power supply connector and an RS232 connector:
Power supply connector Use this connector to attach a power supply to the
HomeBase. The power supply provides 12V DC input for communications and
battery charging.
RS-232 Communications Port Use a standard serial cable to connect this port to a host
RS-232 device.
Bottom Panel
A Baud Rate DIP switch is located on the bottom of the HomeBase. The three-
position DIP switch is used to select the communication baud rate. Switch position
and the corresponding baud rates are shown in the chart below.
Figure 17 HomeBase Back Panel
Figure 18 HomeBase Bottom Panel
Baud Rate
Switch
Power
Supply
Connector
RS-232
Connector
N O T E
The HomeBase
Configuration program
cannot be used to select the
baud rate on the Compact
HomeBase.