Hand Held Products 7200/UG - Manual (Page 32)

C H A P T E R 2 D O L P H I N B A S I C S
32 32 32 32
Laser Engine
The Dolphin 7200 is currently available with five scanning options:
• Standard range
• Long range
• High density scanning
• High visibility scanning
• No scan engine
The laser engine converts reflected light into a digital pattern that represents the bar
code data. A clear window covers the laser engine to protect it from dust and dirt.
Image Engine
The Dolphin 7200 2D terminal is available with the following imaging options:
• Standard image engine: scans 2 to 9 in. (5 to 23cm)
• High-Density: scans 2 to 4 in. (5 to 12cm)
Lanyard Eyelet for Optional Wrist Strap
This feature allows a strap to be attached to the Dolphin terminal so that it can be
conveniently secured around the wrist or hooked on to a belt. Not available on the
Dolphin 7200 RF, Dolphin 7200 with Image-Capture or the Dolphin 7200 2D
terminals.
Battery Well
The Battery Well is a recessed area on the back of the
Dolphin that holds the 3.6V battery pack.
Reset Switch
The Reset Switch is located inside the Dolphin terminal and is accessible through a
small opening within the battery well. To reset the Dolphin, remove the label covering
the opening and press the reset switch with a small blunt object such as a paper clip.
Infrared Communications Port
The Infrared Communications Port allows the Dolphin to communicate through the
Dolphin HomeBase to a host serial device.
Battery Charging Contacts
When the Dolphin is placed in the main well of the Dolphin HomeBase, the
Dolphin’s battery pack is charged through these contacts.
N O T E
Under normal
circumstances, you
should never need to
reset your Dolphin
terminal.