Hand Held Products 7200/UG - Manual (Page 139)

C H A P T E R 9 D O L P H I N O S A N D D E V E L O P M E N T S Y S T E M
139 139 139 139
• To send at 38400 baud rate, enter at the DOS prompt instead of .
• To send at 57600 baud rate, enter at the DOS prompt.
Using the Dolphin File Transfer Program and YX in Menu Mode
You can also use YX in menu mode to send and receive files from the Dolphin to
your PC and vice versa with the Dolphin File Transfer program and YX.EXE on the
PC.
Sending Files to the Dolphin
To use a menu for sending files to the Dolphin, follow these steps:
1. Open the Configuration dialog box. Check to make sure the baud rate is set at
57600. This is the default for YX.EXE.
2. Enter at the Dolphin terminal’s DOS prompt.
3. Press and the menu below will appear on your Dolphin terminal’s
screen:
4. In Windows Explorer, select the file to be transferred and, while holding down the
left mouse button, drag and drop the file on the Dolphin File Transfer shortcut on
the desktop. This opens the Dolphin File Transfer program.
5. Press to begin the file transfer. The COMM LED on the Dolphin
HomeBase will blink red and green during the transfer. You can also view the
progress of the file transfer on the Dolphin screen and status bar in the Dolphin
File Transfer program window.
Baud Rate = 57600
F1 - Send File
F2 - Receive File
F3 - Set Baud Rate
F4 - Quit
N O T E
When using the menu,
press to change
to a higher baud rate
Be sure to set
Configuration
Switch 2 in the up
position.