Canon DP-V2421 4K Reference Display User Manual
Page 55
55
OSD Menu
Item
Setting Options (underline indicates factory default)
Color Range
Sets the quantization range.
Automatic
: Sets the range based on signal information automatically.
When "Color Range" is set to "Normal" (
Full, SDI Full (4-1019), Limited
When "Color Range" is set to "Compatible" (
Full (0-1023), SDI Full (4-1019), Limited 1 (64-940), Limited 2 (64-1023)
Note
• Setting is disabled when "ACESproxy (ver. 1.0.1)" is selected for "Picture Mode".
• Operations when "Automatic" is selected are described below.
-
It is set in accordance with the settings if Color Range settings are included in the camera
metadata. When there is "Full Range" metadata in Payload when SDI is selected, it will be
set to "SDI Full".
-
When HDMI is selected, "Full" or "Limited" ("Full (0-1023)" or "Limited 1 (64-940)") is
automatically set according to the HDMI signal information.
-
When SDI is selected, the setting is configured according to the settings for Picture Mode,
Color Gamut, and Gamma/EOTF.
Setting Options
Color Range to be Set
"System Settings"
→
"Compatible Settings"
→
"Color Range"
When "Normal"
When "Compatible"
Picture Mode
DCI-P3
Full
Full (0-1023)
Color Gamut
DCI-P3
Cinema Gamut to DCI
DCI-P3+ to DCI
Gamma/EOTF
Canon Log (HDR)
Canon Log 2 (HDR)
Canon Log 3 (HDR)
S-Log2 (HDR)
S-Log3 (HDR)
Canon Log
Limited
Limited 2 (64-1023)
Canon Log 2
Canon Log 3
Other than the above
Limited 1 (64-940)
• Operations when "Format" is set to "ICtCp" are described below.
-
When "Color Range" is set to other than "Full", "Wave Form Monitor" will display only a
signal set with "Color Range".
-
If "Channel Settings"
→
"Picture Mode"
→
"Type" is "L/R", the right screen's "Color Range"
setting for the following will be the same as set for the left screen:
- When displaying a single terminal’s input in full-screen
- When displaying "2 Sample Interleave" or "Dual Link 3G-SDI" signals