Canon DP-V2421 4K Reference Display - Manual (Page 23)

23 Operating the Video Display
2. Select an item using the jog dial and press it to determine the selection.
The selection frame moves to sub menu.
3. Select an item using the jog dial and press it to determine the selection.
The selection frame moves to setting options.
4. Select the setting using the jog dial.
Settings change according to the operation of the jog dial.
5. Press the jog dial to determine the selection.
The selection frame returns to sub menu.
6. Exit menu.
When you press the MENU button, the selection frame moves up one menu level. Move the selection frame all the
way to the main menu on the top screen and then press the MENU button to exit the menu.
Note
• The following functions can be returned to their factory default settings or their anchor point ( 25) by pressing the RESET
button, after adjusting the image quality.
- "Contrast", "Brightness", "Chroma", "Sharpness", "Power", "Saturation", "Offset", "Slope"
In "User 1-7" mode where you are performing calibration, the setting returns to the value after calibration instead of the
factory default.
• To adjust image quality, warming-up is necessary to stabilize the brightness of the video display. Wait at least 10 minutes
after turning on the power before using.
• The OSD menu and slider will disappear automatically if no operation is performed for approximately 1 minute. The F
button will disappear automatically if no operation is performed for approximately 10 seconds.
• The settings that cannot be set, are grayed out.