Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 - Manual (Page 40)

Completing the Installation
3-18 Installation
Figure 3-8 Matrix DFE Startup Screen Example (N7 Chassis)
Completing Installation of DFE-Diamond Module in an Existing System
In an established DFE‐Diamond module system,
• a DFE‐Diamond module is already established as the management module,
• the passwords have already been set for various users,
• the system IP address is set, and
• other system parameters have been set.
When you install a new DFE‐Diamond module into a system with an existing configured user
account, the current system settings in that account are already recognized by the new
DFE‐Diamond module and it will operate accordingly.
If you need to change any settings, you can connect a terminal to the local console port as
described in “
Connecting to COM Port for Local Management ” on page 3‐11 to access system
management, or use a Telnet connection to access the DFE‐Diamond module system management
as described in Chapter 3 of the Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide.
Logging in with an Administratively-Configured User Account
If the device’s default user account settings have been changed, proceed as follows:
1. At the login prompt, enter your administratively‐assigned user name, press ENTER.
2. At the Password prompt, enter your password, press ENTER.
The notice of authorization and the Matrix prompt displays as shown back in Figure 3‐8 .
login: admin
Password:
M A T R I X N7
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: [email protected]
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2003
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
Matrix N7(su)->
Note: Users with Read-Write (rw) and Read-Only access can use the set password
command to change their own passwords. Administrators with Super User (su) access
can use the set system login command to create and change user accounts, and the set
password command to change any local account password. For information on the set
password and set system login commands, refer to Chapter 3 in the Enterasys Matrix DFE-
Diamond/Platinum Series Configuration Guide .