Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 - Manual (Page 19)

Management
Matrix DFE-Platinum Series Module Installation Guide 1-3
Figure 1-2 7KR4297-04 DFE-Diamond Module
XFP 10GBASE-LR, -ER, -LX4, and -SR PHY S
The LAN XFP PHYs (physical interfaces) provide inexpensive, high‐speed Ethernet connectivity.
These PHYs provide network managers the ability to use 10‐Gigabit Ethernet technologies to
provide high‐speed, local backbone interconnections between large capacity switches. As demand
for bandwidth increases, network administrators can deploy 10‐Gigabit Ethernet throughout the
entire network to improve server farm, backbone, and campus‐wide connectivity.
Management
Management of the module can be either in‐band or out‐of‐band. In‐band remote management is
possible using Telnet, Enterasys Networks’ NetSight
® management application, or WebView™
application. Out‐of‐band management is provided through the RJ45 COM (Communication) port
on the front panel using a VT100 terminal or a VT100 terminal emulator.
Switch Configuration Using WebView
Enterasys Networks’ HTTP‐based Web management application (WebView) is an intuitive web
tool for simple management tasks.
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete switch configuration management
tasks.
For CLI command set information and how to configure the module, refer to the Enterasys Matrix
DFE‐Diamond/Platinum Series Configuration Guide.
1 RJ45 COM (also known as Console Port) 6 XFP option slot 3
2 CPU LED 7 XFP option slot 4
3 XFP option slot 1 8 OFFLINE/RESET switch
4 TX (transmit) & RX (receive) LEDs 9 MGMT LED
5 XFP option slot 2