beautypg.com

Troubleshooting, Using lanview, About the management (mgmt) led – Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 User Manual

Page 43: Chapter 4: troubleshooting, Using lanview -1, Chapter 4

background image

Matrix DFE-Platinum Series Module Installation Guide 4-1

4

Troubleshooting

This chapter provides information concerning the following:

Unless otherwise noted, the following information applies to all DFE‐Diamond modules.

Using LANVIEW

The modules use a built‐in visual diagnostic and status monitoring system called LANVIEW. The 
LANVIEW LEDs (

Figure 4‐1

) allow quick observation of the network status to aid in diagnosing 

network problems. 

About the Management (MGMT) LED

The MGMT LED (shown in 

Figure 4‐1

) indicates when the module is serving as the Management 

Module to control the management functions for all DFE‐Diamond modules in the chassis. The 
Management Module handles all IP requests to the chassis IP address, such as PING, Telnet, 
SNMP, HTTP, etc. The Management Module also handles the CLI configuration sessions via the 
console port. So, when you plug into a DFE‐Diamond module COM port to configure a 
DFE‐Diamond module in the chassis, it is handled by the Management Module regardless of the 
DFE‐Diamond module COM port that you use. 

CPU, Receive, and Transmit Activity LEDs

The CPU LED indicates when the module has power, is booting, running properly, being reset, or 
shutting down. There is also a set of RX and TX LEDs for each 10 Gbps port. These LEDs indicate 
if the port is receiving/transmitting, linked, and passing traffic.

For information about...

Refer to page...

Using LANVIEW

4-1

Troubleshooting Checklist

4-4

Overview of DFE-Diamond Module Shutdown Procedure

4-5

Recommended Shutdown Procedure Using OFFLINE/RESET Switch

4-6

Last Resort Shutdown Procedure Using OFFLINE/RESET Switch

4-7

This manual is related to the following products: