Location of dimm and dram simm memory modules, Dram simm replacement procedure, Removing the dram simm – Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 User Manual
Page 57

Memory Locations and Replacement Procedures
Matrix DFE-Platinum Series Module Installation Guide B-3
Location of DIMM and DRAM SIMM Memory Modules
shows the locations of the DIMM and DRAM SIMM on the main board.
DRAM SIMM Replacement Procedure
To remove and replace the DRAM SIMM on the 7KR4297‐xx, refer to
and
respectively, and proceed as follows:
Removing the DRAM SIMM
To remove the existing DRAM SIMM, proceed as follows:
1.
Locate the DRAM SIMM connector on the main PC board. Refer back to
.
2.
Push the connector arms away from the DRAM SIMM, as shown in
, enough to
release the DRAM SIMM from the connector fingers.
Figure B-2 DIMM and DRAM SIMM Locations
1 DIMM
2 DRAM SIMM
3 Main PC board
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.