beautypg.com

Connecting to a vt series terminal, Connecting to a vt series terminal -13, Connecting an ibm pc or compatible device -12 – Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 User Manual

Page 35

background image

Connecting to COM Port for Local Management

Matrix DFE-Platinum Series Module Installation Guide 3-13

Connecting to a VT Series Terminal

To connect a VT Series terminal to an Enterasys Networks DFE‐Diamond module COM port 
(

Figure 3‐6

), use a UTP straight‐cable with RJ45 connectors and an optional RJ45‐to‐DB25 female 

adapter, and proceed as follows:

1.

Connect the RJ45 connector at one end of the UTP straight‐cable to the COM port on the 
Enterasys Networks module.

2.

Plug the RJ45 connector at the other end of the UTP straight‐cable into the RJ45‐to‐DB25 
female adapter.

3.

Connect the RJ45‐to‐DB25 adapter to the port labeled COM on the VT terminal.

4.

Turn on the terminal and access the Setup Directory. Set the following parameters on your 
terminal:

Figure 3-5 Connecting an IBM PC or Compatible Device

1 UTP straight-cable with RJ45 connectors

3 RJ45-to-DB9 PC adapter

2 RJ45 COM port

4 IBM PC or compatible device

Parameter

Setting

Mode

7 Bit Control

Transmit

Transmit=9600

Bits Parity

8 Bits, No Parity

Stop Bit

1 Stop Bit

This manual is related to the following products: