Last resort shutdown procedure, Using offline/reset switch – Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 User Manual
Page 49

Overview of DFE-Diamond Module Shutdown Procedure
Matrix DFE-Platinum Series Module Installation Guide 4-7
Last Resort Shutdown Procedure Using OFFLINE/RESET Switch
To reset a DFE‐Diamond module without it performing an orderly shutdown routine,
press and hold the OFFLINE/RESET switch for approximately 6 seconds.
Pulling any DFE‐Diamond module out of the chassis before it has been shut down is not
recommended. The only safe time to pull a module out of the chassis is after the completion of a
shutdown and the management LED is flashing amber/off.
Caution: This method of shutting down a DFE-Diamond module is not recommended except as a
last resort, because all processes currently running on the module will be interrupted resulting in
loss of frames.
Precaución: No se recomienda utilizar este método para apagar los módulos DFE-Platinum.
Recurra a él sólo como último recurso, puesto que interrumpe todos los procesos del módulo en
funcionamiento, lo que podría resultar pérdidas de frames.